ENEA asked CSM to perform a preliminary characterization on EP302 austenitic steel. CSM has been asked to manufacture one ingot EP302 austenitic stainless steel, to manufacture 15 mm thick hot rolled plates, and to assess microstructure and properties of these plates after a final heat treatment in order to optimize the quality of the product. In this part of the activity two hot rolled plates with a final thickness of 15.8 mm and with dimension 145 mm x 1500 mm, in compliance with the requirements for the chemical composition of EP302 stainless steel, have been manufactured
EP302 Stainless Steel Procurement
2012-09-18
Abstract
ENEA asked CSM to perform a preliminary characterization on EP302 austenitic steel. CSM has been asked to manufacture one ingot EP302 austenitic stainless steel, to manufacture 15 mm thick hot rolled plates, and to assess microstructure and properties of these plates after a final heat treatment in order to optimize the quality of the product. In this part of the activity two hot rolled plates with a final thickness of 15.8 mm and with dimension 145 mm x 1500 mm, in compliance with the requirements for the chemical composition of EP302 stainless steel, have been manufacturedFile in questo prodotto:
| File | Dimensione | Formato | |
|---|---|---|---|
|
NNFISS-LP3-044.pdf
accesso aperto
Licenza:
Creative commons
Dimensione
1.7 MB
Formato
Adobe PDF
|
1.7 MB | Adobe PDF | Visualizza/Apri |
|
RdS-2012-044 Frontespizio.pdf
accesso aperto
Licenza:
Creative commons
Dimensione
114.44 kB
Formato
Adobe PDF
|
114.44 kB | Adobe PDF | Visualizza/Apri |
I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.
